Can anyone ID this Poulan

[jason6586]

can anyone ID this Poulan, I know it’s not much to go off of but let’s see I guess.

Thanks

 

[Sam R]

It's older'n heck, I can tell you that. Maybe a Wild Thing?

 

[cus_deluxe]

a countervibe of some sort, 3400 is the most likely answer. meausre the bore and that will tell you whats what.

 

[cus_deluxe]

i think they are standard size bores (not metric) but could be wrong but these should get you close, 45mm-3400,47mm-3700, 49mm-4000. i think there were some with thin rings?

 

[s sidewall]

Don't forget 3800 also

Steve

 

[s sidewall]

3700 thin ring

Steve

 

[cus_deluxe]

i knew there was somethinw the thin rings, forgot the 3800,you are right steve.

 

[s sidewall]

If the piston and cylinder isn't scored, you're in business

Steve

 

[s sidewall]

Take the muffler off and get us a good picture of the piston and exhaust port with the rings showing. Forgot to add, you can take a popsicle stick, stick it into the exhaust port and bring piston up and get a mark on the wood, then measure impression to figure out the bore diameter.

Steve

 

[ATpro]

There is a 4200 and a 4400 also but it is one in that series of pro saws they made. Got a 4000 Bow ( 3.9 cu. in. (65cc) and it's still running after 30 years. Cut a many a cord of firewood and still going strong.

 

[jason6586]

I thought they made a 5200 also

 

[s sidewall]

First one is a 5200, second one with bow is a 3700.

Steve

 

[Wood Doctor]

It might be a 4000 like this one:

Mine runs.

 

[s sidewall]

Yours still looks better than mine.
I did a no no on the cylinder cover, don't clean with purple power, ask me how I know.
Steve

 

[cus_deluxe]

I thought they made a 5200 also

yes, but its a different chassis.