hardpan
Addicted to ArboristSite
Good one Brad
FYI, the 461 has a rev limiter.Subscribed!
Just picked up an MS461R
I'm not sure. Just take it noticeably rich and then slowly lean it out until it time clean in the cut when hot.Thanks for the info.
I'll be sure and keep it off lean at wot. What is the rev limit rpm? Stihl EDT 8 should be here in a few days
Sounds perfect.Cool thanks brad! I'm also going to order a dual port muffler for it tomorrow and open up the port under the deflector. Is that opening it up to much and I should only do one or the other?
Subscribed!
Just picked up an MS461R
$170 a pop from baileys?. I'll see what my dealer will try to charge me for one tomorrow when I order the DP cover.Get a 460 coil.
I thought I'd try and compile all the threads and vids I've done showing how to tune a chainsaw.
Tuning a 3120 with an adjustable carb.
Demonstrating a MS440 tuned a little too rich, then leaning it out.
http://www.arboristsite.com/community/threads/video-how-to-tune-a-chainsaw.113538/
Checking the H tune on a 350, 4-stroking at WOT.
Checking the tune in the wood on the same 350.
Checking the tune in the wood with a 346XP.
http://www.arboristsite.com/community/threads/checking-your-tune-in-the-wood.154314/
post it right here I thinkWould it be possible for me to email someone a short video of my old Homelight SXL? I just retuned the carb and I am new at this and want to make sure it's not running too lean or too rich.
Unless it leans out a lot as it gets hot, you're not too lean. For best results, you now need to fine tun it in the cut.
Enter your email address to join: