Chinese saw bad coil

[doubletrouble]

I have a timberpro cs6150 Chinese saw and no spark. I checked the coil, pretty sure it's bad. Been looking for one. Haven't been able to find one saying it'll fit the 67cc saw I have. Will the coil for a 58cc work? I've found several of those. Going to replace the on/off switch as well since I boogered it up.
Thanks.

 

[TBS]

They will work.
https://www.ebay.com/itm/Ignition-C...ese-Chainsaw-Timber-Pro-Bluemax-/323797935839

 

[doubletrouble]

Thanks. I'll get one ordered.

 

[doubletrouble]

Does the on/off switch just ground the coil to kill the ignition? That's my understanding but just want to make sure. Thanks again.

 

[NSEric]

Yes.
It's pretty clear what the on/off switch does once you take it apart.
PS I have the toggle on/off switch off a 52cc Chinese saw on my timberpro now not the stock rocker switch, it fits the stock cover like its meant to be there.
I thought my switch was bad and cut the wires off it to remove it but all that was wrong was the wire pulled out of the coil so I wrecked the switch for nothing lol.

 

[Mad Professor]

Is it 100% genuine Chinesium?

 

[doubletrouble]

NSEric, not sure what switch you used but I will look around to see if I can find out. If you have a pic or link that would help also. Thanks ........

 

[NSEric]

This is the same switch I took off my 52cc Chinese parts saw.
You will need the rubber piece that holds it too.
https://www.ebay.ca/itm/45CC-52CC-5...318097?hash=item3b2ea026d1:g:7ucAAOSw57xcomUb

I seen a coil with a on/off switch while looking for the switch.

Parts are all over ebay, aliexpress and amazon, most everything on that saw is the same as the 52cc ones.

 

[doubletrouble]

Thanks again. Ordered the switch. Replaced the coil today, she starts now. Used the choke to kill the engine for now but at least it runs. Once the switch gets here I'll get it installed.