Cordless Chainsaws and Outdoor Power Equipment

Arborist Forum

Help Support Arborist Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Philbert

Philbert

Chainsaw Enthusiast
. AS Supporting Member.
Joined
Nov 25, 2006
Messages
19,719
Location
Minnesota
I have to take a pass on some of the technical issues, including optimizing the torque/speed/power consumption design decisions with the motors. Not sure when more voltage is 'better', or past a practical point of diminishing returns. Why 20 cells and not 21 or 23? I like to know what is going on inside, but I can only really comment on the user experience of the product.

I think that the backpack batteries could be useful for some tools and tasks, such as running a string trimmer down a long path, where the user covers large distances on foot, rather than sawing and pruning, which are typically done more within a defined area, and where the cord and weight of a backpack could be an issue.

That said, I could see a lot of ham radio operators salivating at these batteries for 'field day' operations!

Philbert
 
zemmo

zemmo

ArboristSite Operative
Joined
Dec 3, 2006
Messages
491
Location
Glenwood, New Mexico
I have to take a pass on some of the technical issues, including optimizing the torque/speed/power consumption design decisions with the motors. Not sure when more voltage is 'better', or past a practical point of diminishing returns. Why 20 cells and not 21 or 23? I like to know what is going on inside, but I can only really comment on the user experience of the product.

I think that the backpack batteries could be useful for some tools and tasks, such as running a string trimmer down a long path, where the user covers large distances on foot, rather than sawing and pruning, which are typically done more within a defined area, and where the cord and weight of a backpack could be an issue.

That said, I could see a lot of ham radio operators salivating at these batteries for 'field day' operations!

Philbert
10 cells in series gives you 37 volts.
 
Philbert

Philbert

Chainsaw Enthusiast
. AS Supporting Member.
Joined
Nov 25, 2006
Messages
19,719
Location
Minnesota
10 cells in series gives you 37 volts.
OK, but why not 11 cells and get 40.7? EGO Power claims 56 volts (= 15 cells?). Is there something electrically that coincides with these steps in battery power (e.g. dynamics of the motor or wiring), or just that we like multiples of 10 (as Tom Leher might say, because we have 10 fingers) and even numbers (calling it '36' or '40' volts instead of '37')?

Philbert
 
Franny K
Joined
Jan 16, 2013
Messages
4,405
Location
North eastern Ct USA
The back packs would have more series chains hooked up in parallel if they use the same cells as the snap in battery I would think.

Cycle Performance 80% of initial capacity at 300 cycles

They only had tulip or yellow poplar to test it on, and it was knot free and to be cut at 90 degrees. Even though I had seen a cut away picture of the Husqvarna one I had to ask the guy if it had planetary reduction as it made quite a bit of whirring sound. Maybe a .043 3/8 lo pro chain and a spur sprocket makes that much noise all by itself. He said it was direct drive. I guess it was acceptable kind of suprising how little difference the economy mode made which may just be slower chain speed.

Not sure why the local shop has sent out his first one, just like his first t540 to a tree guy on a try before you buy basis but no one (at least in this country) on here seems to be posting their experiences like for the t540.
 
zemmo

zemmo

ArboristSite Operative
Joined
Dec 3, 2006
Messages
491
Location
Glenwood, New Mexico
You probably should edit 650 to 65 from what I just looked up.
The back packs would have more series chains hooked up in parallel if they use the same cells as the snap in battery I would think.

Cycle Performance 80% of initial capacity at 300 cycles

They only had tulip or yellow poplar to test it on, and it was knot free and to be cut at 90 degrees. Even though I had seen a cut away picture of the Husqvarna one I had to ask the guy if it had planetary reduction as it made quite a bit of whirring sound. Maybe a .043 3/8 lo pro chain and a spur sprocket makes that much noise all by itself. He said it was direct drive. I guess it was acceptable kind of suprising how little difference the economy mode made which may just be slower chain speed.

Not sure why the local shop has sent out his first one, just like his first t540 to a tree guy on a try before you buy basis but no one (at least in this country) on here seems to be posting their experiences like for the t540.
Yep, brain fart, 65mm. Off to a javelina roast!
 
GrassGuerilla

GrassGuerilla

Olympic Piss-reving wanna be.
Joined
Nov 27, 2012
Messages
2,869
Location
Just south of St Louis Mo.
I'd imagine the biggest challenge as usual is scrubbing off heat generated. The size of the heat sinks and efficiency of the cooling solution limiting its voltage capacity.

I've had some experience with 18650 cells in rechargeable flashlights. Failures are rare, but scary. Most happen either while hot charging, or during extreme discharge. Failure under extreme discharge rates results in a spectacular flame out. There have been reports of cheap Chinese cells exploding rather spectacularly during charging. So beware the modder of the risks at hand. That said, as a former rc car guy, good cells can make a HUGE impact on performance.
 
zogger

zogger

Tree Freak
Joined
Nov 23, 2010
Messages
16,456
Location
North Georgia
80 Volt Cordless Chainsaw!!!

This probably deserves it's own thread, but I figured the Li-ion folks were already 'here'.
http://www.greenworkstools.com/80v-pro/80v-pro-chainsaw/80v-18inch-chainsaw/

18" bar, 3/8 (low pro?) chain, weight (?), $349 list with charger and 2.0 Ah battery.

View attachment 389370

(It's like one of Zogger's predictions coming true! I'll have to start paying attention to what he says now).

Philbert

Quick! someone buy one and try it out!! hahaha!

Hmm, predictions..silver, being both an ancient form of money and also an industrial use metal, is really underpriced today..socking some away won't hurt...

Told my girlfriend to add some alibaba to her portfolio with their IPO, she listened and is up..40%? Something like that so far.
 
zemmo

zemmo

ArboristSite Operative
Joined
Dec 3, 2006
Messages
491
Location
Glenwood, New Mexico
Quick! someone buy one and try it out!! hahaha!

Hmm, predictions..silver, being both an ancient form of money and also an industrial use metal, is really underpriced today..socking some away won't hurt...

Told my girlfriend to add some alibaba to her portfolio with their IPO, she listened and is up..40%? Something like that so far.

All over it! Gold, platinum, and palladium, too.
 
zemmo

zemmo

ArboristSite Operative
Joined
Dec 3, 2006
Messages
491
Location
Glenwood, New Mexico
mvb1130

mvb1130

ArboristSite Member
Joined
Sep 1, 2014
Messages
81
Location
Norwood, Ohio
I used the 80v green works saw at the gie expo and it was really nice I was cutting 12" pieces of Sycamore. The saw had good speed and torque it was the best battery operated saw I used. I used the husky, and the Oregon as well. It is just nice to think about not messing with fuel, air filters, plugs and carbs. Cheers
 
Chainsaw10

Chainsaw10

ArboristSite Operative
Joined
Dec 18, 2014
Messages
221
Location
Hudson Valley NY
I just did a search on YouTube for 80v Greenworks Chainsaw. There's two quick vids of some Chinese dude in a blue suit making a cut with it. It looks like a hunk of crap to me(just like other Greenworks stuff)....I think my stihl 36v saws would cut just as fast as what's shown in those videos. ....or maybe it's just those vids, I'd like to see more.
 
Philbert

Philbert

Chainsaw Enthusiast
. AS Supporting Member.
Joined
Nov 25, 2006
Messages
19,719
Location
Minnesota
I just did a search on YouTube for 80v Greenworks Chainsaw.
Interesting. When I searched YouTube for 'Greenworks 80 Volt Chainsaw' I only found videos of their 40 volt and smaller models. When I used your term, '80v Greenworks Chainsaw', I found the ones you mentioned!

Linking them here for others:





But you are correct - more voltage is not necessarily 'better', 'faster', 'stronger', or make for a better saw by itself. Those videos are not impressive, but it is hard to know what wood they are cutting, or the condition of the chain. That's why we want to try them side-by-side, like you did with the Ryobi and STIHL!

Philbert
 
mvb1130

mvb1130

ArboristSite Member
Joined
Sep 1, 2014
Messages
81
Location
Norwood, Ohio
Well just by looking at the ground that chain is probably fried, look at all the cookies. That is cherry from what it looks like, not soft wood for sure. I don't know why I am fighting for the saw lol. Well I am fighting for it because it was the best one I ran at the convention and 80v makes a big difference from what I saw.
 

Latest posts

Top