Craftsman 3.3 help

[wv311]

Picked up a clean 3.3 for 25 bucks today that doesn't run. I put a little mix in the carb and it fired right up. It looks like the fuel line has been replaced. My question is where the fuel line comes from the tank there is another hole beside of it that's open. Should there be a tank vent here or possibly another hose ?

 

[scottr]

Picked up a clean 3.3 for 25 bucks today that doesn't run. I put a little mix in the carb and it fired right up. It looks like the fuel line has been replaced. My question is where the fuel line comes from the tank there is another hole beside of it that's open. Should there be a tank vent here or possibly another hose ?

The fuel line goes in the small hole and the tank vent goes in the large hole .

 

[wv311]

The fuel line goes in the small hole and the tank vent goes in the large hole .

Any source for parts for these ? The vent is missing I checked eBay with no success.

 

[scottr]

Any source for parts for these ? The vent is missing I checked eBay with no success.

My Husqvarna dealer orders Poulan parts and guys on this forum and the Tradin'Post chainsaw parts forum can get you the duck bill valve . Did you search duck bill valve ? Is the impulse line good ?

 

[wv311]

So any check valve on the end of a piece of fuel line going into the tank would work. Is this correct ?

 

[scottr]

So any check valve on the end of a piece of fuel line going into the tank would work. Is this correct ?

Here , Poulan 530026119 duckbill valve . Any good small engine repair shop should have them .

 

[HarleyT]

Find a tag on the saw with a 8-9 digit model number, or at least put up a photo of the saw, for any real help.

 

[s sidewall]

Should be a barbed fitting that go's into the vent line from inside the fuel tank, check valve go's on the other end of fitting and vent line is pulled into the tank hole making a tight seal. Vent line routes up behind the carb. Most them came with a sintered brass plug filter in the end of the line.

Steve Sidwell, Samsung On5 using Tapatalk

 

[wv311]

The empty hole is the one for the vent is this correct?

 

[s sidewall]

Correct

Steve Sidwell, Samsung On5 using Tapatalk

 

[HarleyT]

http://www.ereplacementparts.com/vent-fitting-p-234906.html

 

[HarleyT]

http://www.ereplacementparts.com/poulan-335-gas-chainsaw-parts-c-16962_17147_289615.html

 

[s sidewall]

Get your lines routed correctly?

Steve Sidwell, Samsung On5 using Tapatalk

 

[RedneckChainsawRepair]

 

[wv311]

I ordered all new lines and check valve. Should be here this week.

 

[RedneckChainsawRepair]

 

[RedneckChainsawRepair]

I ordered all new lines and check valve. Should be here this week.

Did you get the white piece that goes in the line and duckbill goes onto. Might be in your tank laying around.

 

[wv311]

Yes sir I ordered it too. Where is the hose from it going ? I'm your pic I see it going up over the carb and disappears

 

[RedneckChainsawRepair]

Yes sir I ordered it too. Where is the hose from it going ? I'm your pic I see it going up over the carb and disappears

Thats it. It ends.

 

[s sidewall]

That's where, if you can find one, the sintered brass plug filter went.

Steve Sidwell, Samsung On5 using Tapatalk