May have to try it on the 441 nowAccording to this thread's title, I think you should have put that bar on a 441 as they already have a fat bottom. It would be like tight white pants on a 300 +pound gal. Seriously, I bet that chain just cannot get a big enough bite to cut well with that powerhead.
So what you are saying ,is with this bar and chain the 026 may whoop up on the 660 in 50cc sized wood ?Right..we got to pay attention to detail In this case its ALL about the chain. Sometimes people upgrade to a bigger saw and are dissatisfied that the smaller one may be faster
but they are cutting 8 in trees.
The bigger saw holds no real advantages providing the wood isn't big enough to slow the small saw and ofter the little on has a speed advantage.
What i'm saying is…So what you are saying ,is with this bar and chain the 026 may whoop up on the 660 in 50cc sized wood ?
What i'm saying is…
The angle of the dangle is equeal to the mass of the azz providing and only providing the heat of the meat is constant.
Newbie 's DO NOT TRY THIS AT HOME
Enter your email address to join: