You can become a Supporting Member which comes with a decal or just click here to donate.
I use bleach, watered down a bit, we were told to leave it on surfaces for a few minutes,This saw came to me as a non runner.
Put a in new primer bulb and a new recoil rope and it now runs good. Muffler has been modded. Brand new oem clutch and brand new oem cylinder and piston!
$400 f&f plus shipping
Need funds to buy TP and Hand sanitizer.
View attachment 807018View attachment 807019View attachment 807021View attachment 807022
6100 uses small husky mountDoes Dolmar have their own bar mount?
So, you bought the saw?Me too. I’ll have to get some. Thanks
Congratulations. I like mine. It's a beast of a saw. Cranks easy and runs great. My only complaint is it is stingy with bar oil.Yes sir
I run a 20" on mine. It would probably pull a 24" just fine but I don't know if it would oil it very well.What’s the biggest bar you’d run on it? I’m thinking a 28” is too big so 24” might be the ticket.
Yes, I broke the pin in the oil pump trying to turn it farther than it was supposed to go. I ordered a new pump for it and it's still stingy with oil. It's ok cutting green wood but cutting dead hardwood is when I see chain getting very dry.Do you have your Oiler turned up?
I would just see how yours oils when you get it and go from there. Some folks say theirs oil great and some a little stingy.Hmm, I wonder if there’s any way to increase the flow otherwise.
Enter your email address to join: