VINIFIREWOOD
I only no what I know
Back in march I purchased a new Dolmar 7910 to replaced a wounded 7900.
Awesome saw, like it as much as the 7900 it replaced.
Recently it has developed a starting issue. Always the first start of the day it seems to flood.
My starting procedure is to flip the switch to run position, pull out choke, pull engine over till it pops(usually one or two pulls) then push choke in and pull till it starts(again usually one or two pulls).
When new, this was the usual starting procedure. Then as I got some run time on the saw it started to actually start on the very first pull with the choke on. It seemed a little odd but hey who would complain about a saw starting on the first pull right.
Now, using the same old starting procedure the saw wants to or acts as though it floods. One pull with the choke on, then shut choke off, eight to ten pulls to get it to pop and a couple more to get it to start all chocked up puking smoke and lots of throttle to get it cleaned out and running good.
It doesn't want to start at all without the choke either.
Once you have it started and running for the day then it's fine for the rest of the day. But first thing tomorrow it's the same hard start issue.
Awesome saw, like it as much as the 7900 it replaced.
Recently it has developed a starting issue. Always the first start of the day it seems to flood.
My starting procedure is to flip the switch to run position, pull out choke, pull engine over till it pops(usually one or two pulls) then push choke in and pull till it starts(again usually one or two pulls).
When new, this was the usual starting procedure. Then as I got some run time on the saw it started to actually start on the very first pull with the choke on. It seemed a little odd but hey who would complain about a saw starting on the first pull right.
Now, using the same old starting procedure the saw wants to or acts as though it floods. One pull with the choke on, then shut choke off, eight to ten pulls to get it to pop and a couple more to get it to start all chocked up puking smoke and lots of throttle to get it cleaned out and running good.
It doesn't want to start at all without the choke either.
Once you have it started and running for the day then it's fine for the rest of the day. But first thing tomorrow it's the same hard start issue.