DuraVent extended chimney support bracket

[ErnieG]

I'm installing a stainless double wall chimney and I have to clear a 12" eve .
I found this extended support bracket that's supposed to be what I need to use for this ..I'd like to know if anyone's used this particular one and how it worked out ?
I can't find any pics or videos illustrating how it works .
Thanks
Ernie

 

[ElevatorGuy]

You’re not using a class A pipe outside? That bracket looks simple, are you going to stand the whole stack off the house of just 45 around the eve? I’ve also see people go through and eve like that so adding bends wasn’t needed.

 

[ErnieG]

You’re not using a class A pipe outside? That bracket looks simple, are you going to stand the whole stack off the house of just 45 around the eve? I’ve also see people go through and eve like that so adding bends wasn’t needed.

What I'm using is a double wall pipe 6" outside...yes it's a class A
I wanted to stand the whole stack off the bracket which would be roughly 12' of pipe .

I didn't really want to go through the eve or use and fittings to go around the eve . This bracket says it will support up to 20' of chimney and its installed just above the "T"

Ernie

 

[ElevatorGuy]

Does your house have an plywood on it? How tall are needing to go?

 

[ErnieG]

Does your house have an plywood on it? How tall are needing to go?

Yes it has plywood under the vinyl siding on the outside but the inside is bare studs so I can do some extra framing support to hold the bracket.
From where the T comes outta the wall the chimney will be 10-12' high .

Ernie