Dying chainsaw plastic.

[KostasVolos]

I might try this on a couple saws. Only problem is the plastic has deteriorated a bit, no longer smooth and glossy. Might try wet sanding first.

Some "headlight restorer" stuff,a microfiber
or wool piece of cloth and some elbow grease ,
will do miracles,regarding polishing plastic .
You will be amazed!

 

[joe25DA]

Some "headlight restorer" stuff,a microfiber
or wool piece of cloth and some elbow grease ,
will do miracles,regarding polishing plastic .
You will be amazed!

2 in particular, 036 and 046 almost seems like the plastic is deteriorating, it’s gritty. Otherwise the saws are fine

 

[jellyroll]

2 in particular, 036 and 046 almost seems like the plastic is deteriorating, it’s gritty. Otherwise the saws are fine

wet sand with different stages of fine sandpaper and use a heat gun to bring the color around.

 

[PA Dan]

Same here I do dye and water. Let it simmer until it's black enough. A few years ago I did some tests on penetration. Once I get my parts in I just leave them for anywhere from 45 minutes to 90 minutes.

 

[L34]

I would like to do more penetration tests but she won't let me.