echo CS-310

[Liame]

I poured gas in the oil reservoir by mistake. I realized the mistake and poured it out but i am not sure if i should do anything before start using it again. Any advise is appreciated.

 

[Deleted member 149229]

I poured gas in the oil reservoir by mistake. I realized the mistake and poured it out but i am not sure if i should do anything before start using it again. Any advise is appreciated.

Advice: Don’t do it again. You’ll be fine, just fill it with regular bar oil.

 

[Kenskip1]

Don't do it the other way.Pouring bar oil into the mix side of the saw. Makes the saw a bit difficult to start.LOL

 

[Deleted member 149229]

Don't do it the other way.Pouring bar oil into the mix side of the saw. Makes the saw a bit difficult to start.LOL

I don’t think even Startron would help then.

 

[a. palmer jr.]

The worst thing that can happen is the fuel will thin out the bar oil a bit but doubt that will hurt anything. I'd just run it.

 

[gordgord]

Back when I was falling on the Queen Charlotte's, my 2100 would always run out of oil first at the end of the day....I would use the remainder of my gas to get through the shift. It did keep the reservoir clean too.....lol

 

[stubnail67]

shoulda shook it around its how i clean my oil tanks with straight gas.... once or twice per year.... then pour it out leave upside down let dry.... refill with oil ....should oil good then LOl