For years I have cleaned from the roof, using snap together alum pole from a roof snow brush, with wire brush fitted to it. Works ok, but I am getting older for roof climbing !
I would like to clean from bottom, going through a tee that is inboard of the actual stove connection, about 3 ft horizontal, make a hard 90 degree turn in a tee in the flue, and upwards.
Flue is 6 inch smooth stainless liner, inside a masonary/brick chimney, about 18 ft vertical.
I have very little buildup and it is easy to brush.
I expect there will be more mess, but beyond that, are any of the flexible rods soft enough to make that turn, and still push a wire or poly brush upwards?
Thks, kcj
I would like to clean from bottom, going through a tee that is inboard of the actual stove connection, about 3 ft horizontal, make a hard 90 degree turn in a tee in the flue, and upwards.
Flue is 6 inch smooth stainless liner, inside a masonary/brick chimney, about 18 ft vertical.
I have very little buildup and it is easy to brush.
I expect there will be more mess, but beyond that, are any of the flexible rods soft enough to make that turn, and still push a wire or poly brush upwards?
Thks, kcj