mopar969
ArboristSite Operative
Okay so I have a couple project saws that I have been working on. After I rebuild the car I usually turn the L and H screw out 1.5 cause want too rich instead of lean and I usually turn the idle screw two turns out. Again this is after complete rebuild so I have no idea where idle screw was. once saw runs I set the high till it blurps if it shuts off after letting go of wot then the l needs to be set lean a little. Then after L and H are set I adjust the idle.
My concern from a friend is that the idle crew being out two turns may cause saw to be too lean? I would think not but figured I would ask everyone?
My concern from a friend is that the idle crew being out two turns may cause saw to be too lean? I would think not but figured I would ask everyone?