s dangress as all hell KEEP the kids a wayThe screw is 3” or 3.5” diameter. Geared 10-1 and it needs less or more power for tough wood like oak that’s stringy and curvey. It’s got 11 hp Honda engine. Runs on big roller bearings in a oil bath with tranny fluid.i bought the hardened tip on eBay. Said it was to a something kid splitter. It can do some woods at idle like alder or some cherry and maple, ive down 32” Fir on it but some thought oak that’s only 16” or less can stop it and it has no reverse lol. I need to build a jack shaft setup so it will spin at have the speed now View attachment 728460View attachment 728461View attachment 728462View attachment 728464
The hoist is a great idea
The hoist is a great idea
I can get the steel for free but all the hydraulic parts are expensive. I.find used 27 ton ones from tsc or a different brand for 400 to 500I built my own. Still not cheap even with a lot of scavenged parts, but it is the way I wanted it for the most part.
I can’t remember if mines 22 or 28 gallons. I run a 3.5” cylinder so it flies. I can run a 4 way on straight stuff up to 20” or so with no problem. I have it set up to put a 5” cylinder on it but haven’t felt the need to. If I get some real nasty stuff I use the splitter I posted before. That’s got a 8” cylinder on it when she stops something is in there that shouldn’t be.Scrounged parts for a few years, GX390 22GPM 5X24 cyl 15 gallon
Got bout $1100 Canadian into it.
Trailer ball is just sitting there,, I stuff it up inside my hitch when I lock it.
View attachment 785876 .
Enter your email address to join: