David Young
ArboristSite Guru
- Joined
- Nov 27, 2014
- Messages
- 680
- Reaction score
- 855
Continuation of my lathe fund drive.
Well I did a highlight of my build on OH PEA EEEE
I brought it down to the cases. New nachi bearings oem gasket kit except I forgot to put that pesky base gasket in. So the compression is 175.
I rewired it gave it a carb kit husky fuel filter and put in some after market fuel line.
This is all oem except the fuel line and nachi bearings.
I put the best covers I had on it.
The seam on the gas tank was open. The screws were not tight. I cleaned it used seal all and tightened the screws. Hasn’t been a problem.
I’m asking 400 pho plus shipping
Pics coming
Well I did a highlight of my build on OH PEA EEEE
I brought it down to the cases. New nachi bearings oem gasket kit except I forgot to put that pesky base gasket in. So the compression is 175.
I rewired it gave it a carb kit husky fuel filter and put in some after market fuel line.
This is all oem except the fuel line and nachi bearings.
I put the best covers I had on it.
The seam on the gas tank was open. The screws were not tight. I cleaned it used seal all and tightened the screws. Hasn’t been a problem.
I’m asking 400 pho plus shipping
Pics coming