Hello all,
I have a nice 385XP with the HD filter and cover.
This saw starts and runs great and she ain't a bad looker either!
It was actually owned by a homeowner who used it to fell and buck some huge cottonwood trees on his property. It only needed a few little things and a good cleaning.
The things that were done/replaced:
Detail cleaned/disassembled
Carb rebuilt
New impulse line
New oil pump worm
New inner bar plate to protect the case near the studs
New starter recoil cord
Plugged decomp -I don't like them unless you just have to have them
Purchased and installed new HD flocked filter and tall cover
(Original short cover and black/nylon filter will be included as well)
Original muffler was dented, so I replaced with the aftermarket one; I am sure a muffler mod alone would open up a lot more power, and it is already stout!
------------------
The piston and cylinder are original OEM and in good shape as pictured.
Compression of 130 pictured at 6,000 foot elevation, which is actually very strong and equals ~155psi at sea level (20% increase factored for elevation difference between 6,000 and sea level)
The only negative is that the end of the PTO side of the crank where the clip snaps on has a few chunks out of it, but it still retains the clip fine.
I am asking $650 PHO shipped to Con. USA
I also have a 20 inch power match?bar and a 36 inch Carlton bar and chain setup with 2 good chains each that I can include for an additional $140 shipped to Con. USA.
I have a nice 385XP with the HD filter and cover.
This saw starts and runs great and she ain't a bad looker either!
It was actually owned by a homeowner who used it to fell and buck some huge cottonwood trees on his property. It only needed a few little things and a good cleaning.
The things that were done/replaced:
Detail cleaned/disassembled
Carb rebuilt
New impulse line
New oil pump worm
New inner bar plate to protect the case near the studs
New starter recoil cord
Plugged decomp -I don't like them unless you just have to have them
Purchased and installed new HD flocked filter and tall cover
(Original short cover and black/nylon filter will be included as well)
Original muffler was dented, so I replaced with the aftermarket one; I am sure a muffler mod alone would open up a lot more power, and it is already stout!
------------------
The piston and cylinder are original OEM and in good shape as pictured.
Compression of 130 pictured at 6,000 foot elevation, which is actually very strong and equals ~155psi at sea level (20% increase factored for elevation difference between 6,000 and sea level)
The only negative is that the end of the PTO side of the crank where the clip snaps on has a few chunks out of it, but it still retains the clip fine.
I am asking $650 PHO shipped to Con. USA
I also have a 20 inch power match?bar and a 36 inch Carlton bar and chain setup with 2 good chains each that I can include for an additional $140 shipped to Con. USA.