Husqvarna 440

[ryans4022]

Working on a husqvarna xtorq 440 oiler. Looks like the area toward the back of the saw that supports the oiler has been wallowed out. Is there a fix for this? An upgraded oiler? Part numbers? Thank you. Im not sure a new one is going to work for long.....

 

[RiverLogger]

I’d be looking deeper at what caused that. Crank issues? Bearing problems?

 

[Huskitoter]

Are you missing the roller pin (503240905)? Can't tell if it is there or a vacant hole.

Shown here but listed with the crankcase.

https://www.jackssmallengines.com/j...varna/chain-saw/440-e-2009-02/clutch-oil-pump

 

[ryans4022]

Anybody?

 

[ryans4022]

I will check. Was told the saw ran fine just didnt oil and bar oul just ran out of it

 

[ryans4022]

And yes there appears to be a small pin missing. Looks like it fits in the crankcase and rides in the oil pump gear. Sound right? Im afraid with that broken plastic toward the back that the pump wont have support back there and fail prematurely

 

[Huskitoter]

Isn't the pin supposed to support the pump, preventing it from contacting the case? This is just a guess from looking at the diagram.