The bar is 16". The chain is H30, .325 .050. Both have roughly 4 tanks of fuel on them.
The filter was used to make a few cuts.
The carb is the AT 7A.....the one that's been problematic. My saw ran perfect with this except for it stalling/stumbling after idling for several seconds. Some have reported that adjusting the low speed jet (inside the carb behind a brass plug) will fix the issue. I didn't try it. If nothing else, it could be a parts carb. There's been about 3 tanks of fuel ran through it.
New fuel line that, as I understand, mates up to the newest carbs. Never used.
How about $45 for all?
The filter was used to make a few cuts.
The carb is the AT 7A.....the one that's been problematic. My saw ran perfect with this except for it stalling/stumbling after idling for several seconds. Some have reported that adjusting the low speed jet (inside the carb behind a brass plug) will fix the issue. I didn't try it. If nothing else, it could be a parts carb. There's been about 3 tanks of fuel ran through it.
New fuel line that, as I understand, mates up to the newest carbs. Never used.
How about $45 for all?