Johnnybar
ArboristSite Guru
Never intended it to have a chain for the first startup. Only reason it even has a bar is that I find it easier to check oiler leaks and output that way.Dude you have no chain on it..
Never intended it to have a chain for the first startup. Only reason it even has a bar is that I find it easier to check oiler leaks and output that way.Dude you have no chain on it..
Right on the dinner table...you're my kinda guy!I know this post is getting old, but I just put together a 365 kit. I ordered the 52mm top end, extra clutch, e clips, 2 extra drive sprockets and a few others. It was $262.11 total and took 11 days to recieve. Over all the machine work seems to have improved from comments I've read about huztl parts. The plastic isn't oem quality but will serve its purpose.
I haven't had a 372 yet so it took me around 6 hrs to complete. I made a .007 thick base gasket and ended up with .024 squish. Started with ease second pull. However with the high compression and big bore the decompresion valve is a must.
I will order again if a desirable kit presents itself.
Easier sometimes than working in the shop when you have little kidsRight on the dinner table...you're my kinda guy!
Haven't seen a shina BB 372 fail yet, except the one I put together with circlips tucked up inside the piston in a baggy. Lol.
They could be a softer alloy than OEM, but still good for 150 cords. Much better than any anemic stock 365 if you know how to file chain.
I got two 372 BB's loose out on the street, now owned by two woodticks who can't seem to kill them for some unknown reason.
I know this post is getting old, but I just put together a 365 kit. I ordered the 52mm top end, extra clutch, e clips, 2 extra drive sprockets and a few others. It was $262.11 total and took 11 days to recieve. Over all the machine work seems to have improved from comments I've read about huztl parts. The plastic isn't oem quality but will serve its purpose.
I haven't had a 372 yet so it took me around 6 hrs to complete. I made a .007 thick base gasket and ended up with .024 squish. Started with ease second pull. However with the high compression and big bore the decompresion valve is a must.
I will order again if a desirable kit presents itself.
I ported two 50mm and 2 52mm huztl kits the 52s are a handful lolI know this post is getting old, but I just put together a 365 kit. I ordered the 52mm top end, extra clutch, e clips, 2 extra drive sprockets and a few others. It was $262.11 total and took 11 days to recieve. Over all the machine work seems to have improved from comments I've read about huztl parts. The plastic isn't oem quality but will serve its purpose.
I haven't had a 372 yet so it took me around 6 hrs to complete. I made a .007 thick base gasket and ended up with .024 squish. Started with ease second pull. However with the high compression and big bore the decompresion valve is a must.
I will order again if a desirable kit presents itself.
Here's a little update video. I'm running a 28 inch bar as you can see almost buried I wood. I am running it a little rich for break in and show a little 4 stroking in the cut. Should run strong when broke in well.
Haha figures, I ordered a second kit 2 days before the last sale. If I ordered another I may be living in the shop.372 kits are back on sale. 20%
Enter your email address to join: