Identify this bar

[ChoppyChoppy]

Any idea of the brand of this bar?

It's 56" end to end, about 48" measuring powerhead to powerhead (well if 2 saws where bolted to it)

.058" gauge. It's multi pattern, for sure a K095 pattern lines up.

 

[Deleted member 149229]

Pic?

 

[Kensie1988]

Any idea of the brand of this bar?

It's 56" end to end, about 48" measuring powerhead to powerhead (well if 2 saws where bolted to it)

.058" gauge. It's multi pattern, for sure a K095 pattern lines up.

I would have a hard time believing there was a 50+" K095 since that's a small mount husky

Sent from my E6810 using Tapatalk

 

[pioneerguy600]

That will fit some Sachs Dolmars up to the 120 but not the bigger saws.

 

[ChoppyChoppy]

Pic?

Loading them. My phone died before I could get it to load the pics and I fell asleep, been a long week, I think I hit 80hrs on Thursday.
(made the thread on the computer, but pics are on the phone)

 

[ChoppyChoppy]

I would have a hard time believing there was a 50+" K095 since that's a small mount husky

Sent from my E6810 using Tapatalk

I know, but a small mount bar lines up to everything best I can tell. I pulled a K095 bar off the shelf and stuck it over it to check. Large mount is too big from what I can tell.

My buddy thinks it might also be Poulan pattern.

 

[ChoppyChoppy]

Not sure why the first one is upside down, it loads fine on my phone and on Facebook!

 

[Justsaws]

8mm or .315ish puts it in the Mcculloch, Echo, etc mount size, as does the various adjuster and oil holes. That gets you up to 80cc ish on each end.

The KO95 is a wee bit bigger, like 8.2 or so.

 

[ChoppyChoppy]

I'll measure it in a bit

 

[ChoppyChoppy]

Measure .390"