Sold Mac 10-10

[Kensie1988]

I would like to get rid of this clean Mac 10-10. It does run but had no low end while cutting, if you look in through the i take side it shows scoring on the exhaust side. I just want to be rid of it. I was hoping to get $60 plus shipping, there are still a lot of good parts there including the filter.

 

[Just_A_Grunt_1978]

what carb does it have?

 

[Kensie1988]

SDC

 

[Just_A_Grunt_1978]

and it starts up and runs, just no power?

 

[Kensie1988]

Yep, I'll try and start it up again tomorrow just to make sure, I rebuilt the carb thinking maybe that was the issue and the lack of power in the cut was still present

 

[Just_A_Grunt_1978]

do that, let me check on the saw I'm working on and see if I think I can use the parts... Does the bar come with it?

 

[Kensie1988]

do that, let me check on the saw I'm working on and see if I think I can use the parts... Does the bar come with it?

Sure does

 

[Just_A_Grunt_1978]

I'll look at what I'm working on. See if the saw still starts and if it does PM me tomorrow

 

[hseII]

Sure does

Are you on the Other Power Equipment site?

 

[Kensie1988]

Are you on the Other Power Equipment site?

Yes, I am on both

 

[Kensie1988]

Bump

 

[Kensie1988]

Bump

 

[Dan Newton]

PM SENT