My brother wanted his picture posted too.
Posing the mini like he cut this tree
Here he's showing us the next victim of the mini Mac. This tree is 74" on the same property. It's dead and someone had already cut the top out if it but couldn't take the trunk. I don't think they'll let us cut this one. It would take a while with my 38" bar.
looks like a muffler salvaged rim drive drum?:msp_sneaky:
The PM850 (that you generous folks here donated parts for) destined to go to you-know-who is finally almost done after several stops and starts. Engine's back together with new seals and rings. Most everything needed has come in. Thanks again gentlemen. Just chasing down some last few bits. Mostly the lower/front AV mount and the mounting hardware for it and the bottom handlebar brace/skid plate. Randy donated a very nice handlebar, fuel tank, and bottom skidplate/brace.
Nice muffler mod Cliff, you just don't find creative solutions applied much these days.
Mark
Thanks Ron. That's very generous of you. It is the same. The PM850 (that you generous folks here donated parts for) destined to go to you-know-who is finally almost done after several stops and starts. Engine's back together with new seals and rings. Most everything needed has come in. Randy donated a very nice handlebar, fuel tank, and bottom skidplate/brace. Thanks again gentlemen.
Just chasing down some last few bits. I need the 85898 lower/front AV mount and the mounting hardware to attach that mount to the bottom handlebar brace/skid plate and crankcase. I also still need the 93037 shoulder screw that attaches the bottom skidplate/brace to the rear handle. May have one on the way.
Aaron, could you be a little more specific with what you need so I can look for them? Maybe some part numbers. Thanks, Ron
Enter your email address to join: