Modifying large mount husky bar to fit jonsereds 111s

[James Miller]

I've picked up a 111s with no B/C. I read somewhere the DO24 mount bars aren't very common anymore and large mount husky bars can be made to fit. Is this correct or should I just look for a nice older bar to go with the saw.

 

[Kensie1988]

There is a bar on ebay you can buy for the 910/920 that will fit this saw, I believe the bar is 34-36" if you looking for larger bar, then most people just use a flat file and take .25 mm off each side of the bar slot, sometimes a large mount husky can bolt right up because .5 mm may be within the margin of error for defects.

 

[James Miller]

Thank you for the response. I'll look into the bar you mentioned on Ebay.

 

[James Miller]

Shes a bit ruff looking but all the mechanical parts look to be in good shape. Going to clean it up later and see if it will pop. Then I'll have to work on getting a bar.

 

[Kensie1988]

View attachment 733718 Shes a bit ruff looking but all the mechanical parts look to be in good shape. Going to clean it up later and see if it will pop. Then I'll have to work on getting a bar.

Well at least you are among the lucky ones who own one.

Sent from my E6810 using Tapatalk

 

[Huskybill]

I got my sons 910e a bar from eBay. I didn’t know they weren’t h009/d009 like the huskys.