Morning guys. So I’m rebuilding my last 200t from a stockpile of parts, and it seems I left the best til last
I remember now that this saw was chucked on the pile for two reasons; chain brake failure and leaky tank vent. This is confirmed by a perfect vacuum and pressure test and really clean piston and cylinder. I have put new OEM rings on though because I had them lying about.
I have bought a new chain brake bone (old one snapped in half...is that a common failure?) and fitted a new breather kit. On fitting the kit a little orange flappy thing fell out of the fuel tank, kinda like an umbrella without the handle. There is no mention or illustration of this on the new parts install sheet; I have just ordered one from LSE but do I need it? Would the handle just poke up into the hole from inside the fuel tank?
Thanks in advance for any help guys
I remember now that this saw was chucked on the pile for two reasons; chain brake failure and leaky tank vent. This is confirmed by a perfect vacuum and pressure test and really clean piston and cylinder. I have put new OEM rings on though because I had them lying about.
I have bought a new chain brake bone (old one snapped in half...is that a common failure?) and fitted a new breather kit. On fitting the kit a little orange flappy thing fell out of the fuel tank, kinda like an umbrella without the handle. There is no mention or illustration of this on the new parts install sheet; I have just ordered one from LSE but do I need it? Would the handle just poke up into the hole from inside the fuel tank?
Thanks in advance for any help guys