I'm redoing the top end on my saw with used OEM cylinder and meteor piston/caber rings. Will I see any appreciable gains by only eliminating the base gasket? I'm not planning on any port work. The new base gasket measures .019" and the squish is .042". I can get the squish to .023" by ditching the gasket. Should I or shouldn't I? Any major downsides? I'm already leaving out the spark arrestor. Ya'll don't flame me too hard. I've did a lot of reading, but this is my first time rebuilding the top end on a saw. But I do like more power.
Sent from my C771 using Tapatalk 2
Sent from my C771 using Tapatalk 2