MervMaster
ArboristSite Operative
Hey All!
I've been trying to avoid bothering everyone with my problems, but I'm stuck.
MS362 - Starts and runs normally, but won't idle. 4 pulls on choke, switch to half, runs on half, pull the trigger and it spools up and runs wide open with no problem. I don't have a leak testing rig, so I have not eliminated an air leak- but my WOT performance is normal.
Here's what I know:
A spark plug is new and is dry and chocolate brown
The ignition module is tight, and a business card from the flywheel magnet
Clutch springs are intact
Fuel lines, vent, and filter are new
The exhaust is clear, with no rust or carbon.
No tears in the intake boot
The carburetor is ultrasonic clean and blown out
Fresh fuel@50:1
Carb screws set to stock
Please Advise!
I've been trying to avoid bothering everyone with my problems, but I'm stuck.
MS362 - Starts and runs normally, but won't idle. 4 pulls on choke, switch to half, runs on half, pull the trigger and it spools up and runs wide open with no problem. I don't have a leak testing rig, so I have not eliminated an air leak- but my WOT performance is normal.
Here's what I know:
A spark plug is new and is dry and chocolate brown
The ignition module is tight, and a business card from the flywheel magnet
Clutch springs are intact
Fuel lines, vent, and filter are new
The exhaust is clear, with no rust or carbon.
No tears in the intake boot
The carburetor is ultrasonic clean and blown out
Fresh fuel@50:1
Carb screws set to stock
Please Advise!