Junkfxr
ArboristSite Operative
I have a 2010 MS660 that usually wears a 32" bar but I've got a big job coming up next week that's going to need the 42" bar. After putting the big bar on, I flipped the saw over to make sure the oiler adjustment was wide open. The screw slot was pointing at the "E" which I assume stands for Eco friendly. It wouldn't turn any farther clockwise and would only turn counter clockwise a 1/4 turn to the lowest setting. Does the adjustment screw only have 1/4 turn of adjustment on these oil pumps or should it turn farther clockwise? According to the manual that came with the saw, it should go farther clockwise. Looking for some other's experiences and thoughts. I tried using the forum search feature but couldn't come up with anything even though I know this has been discussed before. Apologizes for bringing this back up again.