Spanky
ArboristSite Operative
I was really surprised how my 660 ran the 11 pin sprocket on a cut down 36 inch bar to 32.5 inches and full comp chain. I really thought it would pull the saw down but the sprockets mass holds rpms well.
the sprockets mass holds rpms well.
Ok if the sprockets mass isnt acting like a larger flywheel then I really appreciate the confidence boost on the raw horsepower ability of the saw .
It does through a few Sparks we strobe checked chain speed last night at 10640fpmBrand new RS chain .
It's on YouTube I can't seem to load it on here for some reason but your welcome to view my YouTube channel
Ed Danzer owns 6k productsThis is gonna get good. I wanna see this hotsaw cut some wood! Nothing like a modern era AS performance thread in action with an 11pin super cutty going at it. Piltz would he smiling and giggling watchin this as he checks his cash flow statement for the month.
11 pin, 3/8.It does through a few Sparks we strobe checked chain speed last night at 10640fpm
That's damn fast....raker height & inner top plate angle would need fine tuning. I'd be wearing decent PPE, 'chain shot' could be a micro second you remember for ever.
Lol...yup we know that but watching people doing dangerous stuff is like natures natural selection. Video of 11pin and flipflop's please....It's much more dangerous than the stock setup, but it cuts way worse.
Wait, hold on a minute...
It's much more dangerous than the stock setup, but it cuts way worse.
Enter your email address to join: