stevetheboatguy
ArboristSite Guru
Nice firewood saw. Not all banged up, but not perfectly pretty. Has four tanks through it since it was redone.
Has new 372 oem p&c, nsk or ntn (can't remember but those are the two brands I have been using) c3 crank bearings.
I did install a set of farm tec crank seals (have them on a few and haven't had any problems) but if someone wanted oem installed and wanted to send them to me. I would pull the am and install them no problem and no charge.
The saw runs cuts oils and brakes like it should. No issues that I have found. Although I may swap out the kill switch as it is a little loose.
I put a am clutch cover on the saw and touched up the black stripe on the plastic. The original cover has a chunk missing from a thrown chain. But if someone wanted it instead of the am. I would swap it out.
How does $500+ actual shipping sound. Pho.
Has new 372 oem p&c, nsk or ntn (can't remember but those are the two brands I have been using) c3 crank bearings.
I did install a set of farm tec crank seals (have them on a few and haven't had any problems) but if someone wanted oem installed and wanted to send them to me. I would pull the am and install them no problem and no charge.
The saw runs cuts oils and brakes like it should. No issues that I have found. Although I may swap out the kill switch as it is a little loose.
I put a am clutch cover on the saw and touched up the black stripe on the plastic. The original cover has a chunk missing from a thrown chain. But if someone wanted it instead of the am. I would swap it out.
How does $500+ actual shipping sound. Pho.