Got this new MS193T today, never cranked. Fuel and oil and it fired right up. Warmed it up for a bit and checked for throttle response, seemed really sluggish. Searching around shows these saws respond well to a muffler mod and adjusting the carb. I have no problem opening the muffler but not sure on adjusting the carb.
I got the saw cheap and I really want to learn to tune a saw. Seems the limiter tabs are in my way. I need to cut the limiter tabs off to get full adjustability so I'll get into that tomorrow.....any advice appreciated on easy removal of them. Which way do I turn the carb screws to richen? Seems like turning them counter clockwise will back the screws out, allowing more fuel?
Thanks
I got the saw cheap and I really want to learn to tune a saw. Seems the limiter tabs are in my way. I need to cut the limiter tabs off to get full adjustability so I'll get into that tomorrow.....any advice appreciated on easy removal of them. Which way do I turn the carb screws to richen? Seems like turning them counter clockwise will back the screws out, allowing more fuel?
Thanks