Clarkbug
ArboristSite Operative
Howdy all.
Was recently given a Chain Sharp CS-X by someone that didnt want or use it. Its the model set up for 3/8" chain, but I also am needing to touch up a few 3/8" LP chains. Can I just swap the round files out and use it on both? From looking at the Pferd site the setback for the rakers is the same, but I wasnt sure if there was something else different about the actual guide.
Thanks!
Was recently given a Chain Sharp CS-X by someone that didnt want or use it. Its the model set up for 3/8" chain, but I also am needing to touch up a few 3/8" LP chains. Can I just swap the round files out and use it on both? From looking at the Pferd site the setback for the rakers is the same, but I wasnt sure if there was something else different about the actual guide.
Thanks!