G Grqnbech ArboristSite Operative Joined Sep 27, 2009 Messages 147 Reaction score 71 Location Denmark Nov 22, 2010 #61 yes I have considered using an 028 super P&C... but I will wait till this P&C dies...
CHEVYTOWN13 Addicted to ArboristSite Joined Sep 26, 2008 Messages 2,483 Reaction score 250 Location T.C. CALIFORNIA Nov 23, 2010 #62 It sounds tuned and its cutting great. I'm curious to know once you found this pipe, did you put it on to measure tuned length, and then ported it to tuned length? I can see that working, you obviously have it running great. I agree, extend the stinger a bit. Good job
It sounds tuned and its cutting great. I'm curious to know once you found this pipe, did you put it on to measure tuned length, and then ported it to tuned length? I can see that working, you obviously have it running great. I agree, extend the stinger a bit. Good job
G Grqnbech ArboristSite Operative Joined Sep 27, 2009 Messages 147 Reaction score 71 Location Denmark Nov 24, 2010 #63 first I ported it then I found the pipe and put it on there... I guess it´s luck that it is running so good....:jester:
first I ported it then I found the pipe and put it on there... I guess it´s luck that it is running so good....:jester:
CHEVYTOWN13 Addicted to ArboristSite Joined Sep 26, 2008 Messages 2,483 Reaction score 250 Location T.C. CALIFORNIA Nov 24, 2010 #64 You stuck to your idea, and saw it through. And got it running great. A lot of people would have downed you for the idea. You just proved them wrong
You stuck to your idea, and saw it through. And got it running great. A lot of people would have downed you for the idea. You just proved them wrong
GA_Boy ArboristSite Guru Joined Oct 24, 2010 Messages 606 Reaction score 128 Location FL Nov 24, 2010 #65 nice, runs like a scalded dog. :chainsawguy:
blsnelling Goosme! . AS Supporting Member. Joined Nov 8, 2006 Messages 53,727 Reaction score 33,310 Location Franklin, OH Nov 24, 2010 #66 Your saw is cutting very nicely. But you've got a serious lean run-on condition when you come off the throttle. Try opening up the L needle some more. That may take care of it.
Your saw is cutting very nicely. But you've got a serious lean run-on condition when you come off the throttle. Try opening up the L needle some more. That may take care of it.