Looking to sell my ported husqvarna 350.
Have about 5-7 tanks through it.
Base cut, squish set at .017. Full woods port, nothing radical.
WEM 44.3 346 aftermarket cylinder
meteor piston, caber rings metal intake clamp.
346 muffler brace
New bearings/seals, intake boot,
Treemonkey'ed walbro 199
Idles,cuts, oils as it should.
Only issues I can think of is the high side needle should be replaced. 1/2 of the slot broke off, have to use pliers to adjust.
And a burn/chip at the front of the top cover.
Asking $275 PHO shipped
May trade for othe 3 series saws/builders
Have about 5-7 tanks through it.
Base cut, squish set at .017. Full woods port, nothing radical.
WEM 44.3 346 aftermarket cylinder
meteor piston, caber rings metal intake clamp.
346 muffler brace
New bearings/seals, intake boot,
Treemonkey'ed walbro 199
Idles,cuts, oils as it should.
Only issues I can think of is the high side needle should be replaced. 1/2 of the slot broke off, have to use pliers to adjust.
And a burn/chip at the front of the top cover.
Asking $275 PHO shipped
May trade for othe 3 series saws/builders