Sold Pro Mac 805 project $160 shipped

[Kensie1988]

I would like to sell my Pro Mac 805 project, I just don't have time for it and I'm also trying to pay off my truck so we won't be hurting so bad paying for daycare for my 3 month old. Below is just a snap shot, I can get better pictures upon request. I would like to get $200 shipped, the saw cosmetically is in good shape, put some antivibe mounts and fastners will need to be replaced for sure.

Sent from my E6810 using Tapatalk

 

[rwoods]

What condition is the cylinder? The piston? The starter housing, recoil and sawdust screen?

Thanks, Ron

 

[Kensie1988]

Saw dust screen is good, when I checked the piston it had light scoring, looking from the intake side I believe the cylinder looked good, but I will check again

Sent from my E6810 using Tapatalk

 

[Kensie1988]

Screen is good, piston is done, it was a lot worse than I remember that's for sure, but I pulled the carb to see the exhaust side of the cylinder and I don't know if it will be salvageable, I tried to take a couple pictures

Sent from my E6810 using Tapatalk

 

[Kensie1988]

After looking at the condition if the piston and cylinder again I will go $150 shipped to your door, $160 on the west coast.

Sent from my E6810 using Tapatalk

 

[Kensie1988]

Sale pending

Sent from my E6810 using Tapatalk