HoleDigger
New Member
Hey everyone!
Ready for some dumba$$ newby questions?
So I've got an old(new to me) Jonsered 535 that I'm trying to get going for pruning.
Problem is, I can't keep it running. It will usually start, and generally idles, but the minute I hit the throttle it bogs down and dies.
I've set the Hi and Lo screws to where the manual says they should be. 1 - 1.25 turns off bottom for the Lo, 1 turn off bottom for Hi. I fiddled with them a bit after I set them but...
Everything else seems to be hooked up and in place.
Any suggestions or ideas would be greatly appreciated.
Thank you!
Ready for some dumba$$ newby questions?
So I've got an old(new to me) Jonsered 535 that I'm trying to get going for pruning.
Problem is, I can't keep it running. It will usually start, and generally idles, but the minute I hit the throttle it bogs down and dies.
I've set the Hi and Lo screws to where the manual says they should be. 1 - 1.25 turns off bottom for the Lo, 1 turn off bottom for Hi. I fiddled with them a bit after I set them but...
Everything else seems to be hooked up and in place.
Any suggestions or ideas would be greatly appreciated.
Thank you!
Last edited: