Dane d
New Member
i have an 810 xt chipper and the roller feed has recently stopped working or is very very weak.
Does anybody have any advice ?
The chipper only has 800 hours
Does anybody have any advice ?
The chipper only has 800 hours
Are there any other hydraulic features to the chipper? If so, are they acting weak? If they are, you may have a hydraulic pump that is bad.
Hope this helps!
Dave
Global Equipment Exporters
770-420-6400
Ok, it may need a detent kit in the valve that controls the feed bar. It sounds like oil is by passing and not going to the rollers.
Hope this helps!
Enter your email address to join: