Kinda inhereted a three point splitter that has shot craps and would get more use out of it if it were a "regular" configuration. Ex. Helping buddies, old farmers, etc.
So here is what I have to work with:
13 hp B&S industrial/commercial engine
36" 4" sleeve 2" bore cylinder that is in rough but useable shape after I drop a new seals kit in it.
Here is what I would like to do:
Run cylinder with respectable cycle time
Hydraulic log lift
Hydraulic adjustable wedge
What are my options and where do I go frome here?
What GPM pump would accomplish all that without bogging down the engine?
Is this worth doing from a cost benefit standpoint?
What type of valve should I be searching for?
I'm a poor but very handy shop teacher with more time than money - where could i go looking to scrounge needed stuff?
Thanks for all the help! You all kick aacceee! Hellbent
So here is what I have to work with:
13 hp B&S industrial/commercial engine
36" 4" sleeve 2" bore cylinder that is in rough but useable shape after I drop a new seals kit in it.
Here is what I would like to do:
Run cylinder with respectable cycle time
Hydraulic log lift
Hydraulic adjustable wedge
What are my options and where do I go frome here?
What GPM pump would accomplish all that without bogging down the engine?
Is this worth doing from a cost benefit standpoint?
What type of valve should I be searching for?
I'm a poor but very handy shop teacher with more time than money - where could i go looking to scrounge needed stuff?
Thanks for all the help! You all kick aacceee! Hellbent