STihl 026 will not idle.

Arborist Forum

Help Support Arborist Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

4pwr

ArboristSite Member
Joined
Apr 18, 2005
Messages
63
Reaction score
0
Location
michigan
Put saw up in Dec. Did not drain gas. Thought I wwould use it soon. Did not and forgot to drain gas. Now saw starts good, revs good,but will not idle. Do stihls have carb float that is stuck? Is there a carb cleaner out there. Have used sea foam with good success on outboards. Is it ok for saws?
 
There is no "float". It's diaphragm style carb. If it starts and run well, it's not your metering diaphragm. Try adjusting your L screw to 1 turn out from gently seated, and turning up you LA. If that doesn't work, try turning up the L screw to say 1 5 turns. if it idles at 1.5, you should be looking for an air leak in the impulse line, boot or seals.

If the carb L progression jets are blocked (unlikely), the best way to deal with that is to disassemble the carb and clean it in an ultrasonic cleaner. If you don't have access to one, soak it in Naphtha for a few hours. Avoid blasting air though the carb jets it or you'll ruin the H check valve. You can blow gently though...


You also may have a cracked impulse line - Does it idle for a few seconds after you throttle down, or die immediately?.
 
Thank you for your post. Apologize for the delay. I put saw prob on back burner because other things popped up. Can see nothing suspicous . Will keep trying.
 

Latest posts

Back
Top