I bought this saw back in july, and it ran ok nothing too special. I know its a light duty saw, but still.
fast forward to Dec the ice storm hits and I need it.
saw wont run right, so I drained the gas replaced the plug still boggs down when running, not cutting just slowly giving ti gas. so I started adjusting the screws and get it where it would run, now it wont cut even twigs without bogging down and having to fan the trigger.
so I took the saw in for warranty wait 20 days got it back today. I take a large log with me to try it at the shop to see how it cuts, runs good, good idle, I take it home.
I take it out of my truck, get ready to finally clean up my yard. thing runs just as bad as I did when I took it in:bang:
Im pretty sure it was the same gas that I put in it, when I took it to get repaired.
what can I look for, adjust, replace?
or should i just take it back in and wait 2 more weeks to get it back?
fast forward to Dec the ice storm hits and I need it.
saw wont run right, so I drained the gas replaced the plug still boggs down when running, not cutting just slowly giving ti gas. so I started adjusting the screws and get it where it would run, now it wont cut even twigs without bogging down and having to fan the trigger.
so I took the saw in for warranty wait 20 days got it back today. I take a large log with me to try it at the shop to see how it cuts, runs good, good idle, I take it home.
I take it out of my truck, get ready to finally clean up my yard. thing runs just as bad as I did when I took it in:bang:
Im pretty sure it was the same gas that I put in it, when I took it to get repaired.
what can I look for, adjust, replace?
or should i just take it back in and wait 2 more weeks to get it back?