cuinrearview
Red saw lover
I didnt think that there was a problem...I've never done a popoff test. Think ur problem is elsewhere.
I didnt think that there was a problem...I've never done a popoff test. Think ur problem is elsewhere.
Maybe I missed it in one of the threads about this, but did you put it back on the saw and try and run it yet? I've re-built a couple 159s lately and threw them back on the saw. And it runs fine
If you have a tank vent leak it won't hurt the saw, but it is annoying. If you have that part of the saw open at some point I recommend investigating.
Glad to hear you got the carb sorted. Are you still running the trimmed lever spring?
Nah. Take it back apart and make sure the passage under the needle is clear, and make sure the lever height is correct,
a good sealing needle is not a bad thing
Enter your email address to join: