Mark I know the pouland oils tru the hole where the bar adjuster pin fits and the husky bar has a seperate hole, but are there any other differences
I need to be aware of?
I have been running the small mount husky bar on my 2550 with no oiling problems so far.
P.S. Brad the part# for the oregon rim bearing is
ORF37325
Well you have to remember the difference in the tail sizes as well. The A041 and K095 have the smaller tail then the K041 and K095.
Basically if you have a 3/8's lp bar it will be the smaller A041 or K095, if you have a .325 or full 3/8's bar it will be the K041 or K095.
Your right though the main difference is the 095 bars haveing a oil hole and the 041 bars oileing through the adjuster holes.
The 095 bars adjusting holes can be modified to oil though them as well without much hassle. I'm running a Z095 mount on my PP330 that has the adjuster holes filed up till they oil through them.
Ifr you guys are running .325x7 sprockets the larger tail on the K095 bars should work just fine.
Thanks for the bearing # that is a stock bearing size for the Wildthing type saws as well as for the 2500 type saws as well.