Woooo-hooo!
Got the last few wires soldered, all the wiring is done short the brake wiring. Decided, ehh, I'll get it in the air and pull the wheels. By the time I was done, I not only had the tires pulled, but the axles and suspension too!
I just cut the axle bolts off, they were too rusted to try saving them. The spring bolts fought me the entire way, but its all apart. I was worried the holes in the equalizers would be egged out, but I got lucky and they are hardly worn...bushings are gone, but the holes aren't egged. And I found my bronze bushings will fit pretty good, without too much work.
If all goes well, I should have the springs bushed tomorrow, and maybe the suspension hung. Then all that is left is to pull a hub on each axle to find out which direction the axles run (brakes), weld perches on the axles, and sling them under the trailer, and install wheels/tires. Might actually have it done by Christmas!