Ill check the but im pretty sure its 130xxxxxx
It is mostly stock. Has a 046 top end on it and no base gasket.
Squish is at .017
OK, thanks, so that is a 12mm big bore, nice! If it runs like my 046 (which is now ported) you will love it.
Ill check the but im pretty sure its 130xxxxxx
It is mostly stock. Has a 046 top end on it and no base gasket.
Squish is at .017
That is scary... But I'm a chicken.Hey Randy if your around this is what the plug looked like after 5 tanks on the 064, 13,500 rpm fourstrokin heavy.View attachment 368477
What scares me is that it four strokes all the time unless you have it dogged in.That is scary... But I'm a chicken.
Testing my new tach holder on my mastermind 660. Love it!
I love reading rpms. Now the tach can stay on the saw and can be switched to another saw if I wanted to.
WOW Shawn! Where can I get one?!
Dammed imported junk! Is it at least German Engineered?It was made by a guy named Jabroni. I think he came from India?
Hey Randy if your around this is what the plug looked like after 5 tanks on the 064, 13,500 rpm fourstrokin heavy.View attachment 368477
Where you been Hoss, out building fence?That "looks" scary lean.
Did you kill it in a cut, then pull the plug?
If not, you won't get a good reading.
If you pulled it after idling......it might need more fuel on the low side.
I like 13,200 on those saws. Big saw, big wood, lots of fuel.
Where you been Hoss, out building fence?
Enter your email address to join: