Yes on the o ring and oil pick up, adjuster should be fine, I would set the oiler to maximum and check to see where the wear mark ends up, turn it away from the plunger and it should be ok, btw how is the wear surface on the plunger?
dunno.. will strip it out and have a look, the pin that is for the notch on the adjuster is flat too lol and teflon taped the adjuster in as well! backyard repairs at their bestYes on the o ring and oil pick up, adjuster should be fine, I would set the oiler to maximum and check to see where the wear mark ends up, turn it away from the plunger and it should be ok, btw how is the wear surface on the plunger?
thats a great log , well doneCut up a Nice Spotted Gum log today there is more to it than in the pic had to cut about 4.8 meters off that's the butt end in the pics, the 7t forklift wouldn't lift it. I had to unload it one end at a time off the log truck after that I couldn't move it ha.
Before it got 4.8m cut off its weight was about 8 and a half tonne anyway nice log clean wood had some shake but nothing bad we couldn't work around, it cost about 18 hundred bucks for the log and we got over 50 QLD sleepers out of it.
View attachment 502644 View attachment 502645 View attachment 502646
Railway Sleepers.What is a Qld sleeper?
What is the general opinion about treated australian hardwoods. How far in is the treatment getting?
Yeah don't know what was going on there it might have sat back on em? who knows? looks to have been a 20in bar also maybe , but that's nothing you see some real head scratchers loldrove tho forests of Cor mac Spotted gum along nsw coast i kept thinking id fell that one that way this one that a ways
What is a Qld sleeper?
What is the general opinion about treated australian hardwoods. How far in is the treatment getting?
It is being used extensively in pier and wharf construction in marine environments, so I'd say it's pretty good.
Good for rot i guess. What about termite etc. In ground with organic matter presents different problems to in water and sand and clay etc i would think?
The plunger look real good. May give it a kiss on the grinder to make it 100%Yes on the o ring and oil pick up, adjuster should be fine, I would set the oiler to maximum and check to see where the wear mark ends up, turn it away from the plunger and it should be ok, btw how is the wear surface on the plunger?
Enter your email address to join: