Deets066
Firewood hack
It was my crank seal, I finally got around to fixing that saw, well I got the new seal in anyway. Just have to throw it back together and vac test again
Back In The Shop......Now What's On Your Bench????
- Thread starter Mastermind
- Start date
Help Support Arborist Forum:
Mastermind
Work Saw Specialist
Throw it back together? 
Jeremiah
ArboristSite Operative
Fixing a 290 for a poor sap that backed a bobcat over it...
And gotta finish my 075 rebuild.
And my 84.. and and and..
And gotta finish my 075 rebuild.
And my 84.. and and and..
Deets066
Firewood hack
Yep, that's all I got time forThrow it back together?
Jeremiah
ArboristSite Operative
Just finished a 045 carb rebuild fit a friend.. saw runs and oils awesome but when you turn it in its side to oil up the oil dumps out by the chain cover ....?
It still has enough oil to last the tank of fuel out...
The saw was horribly abused when I got it.. the dog/ bumper spike was broken..!! How do you do that?
It still has enough oil to last the tank of fuel out...
The saw was horribly abused when I got it.. the dog/ bumper spike was broken..!! How do you do that?
Deets066
Firewood hack
How long you suppose this would have lasted. 
Junk clips?View attachment 432243 How long you suppose this would have lasted.
Deets066
Firewood hack
It's a newly acquired 660 with an aftermarket top end. I'm guessing it was from installation
View attachment 432243 How long you suppose this would have lasted.
I can't remember which of my old mag. turds (Lombard?) it was, but it had Westinghouse Micarta piston pin plugs instead of clips.
Mastermind
Work Saw Specialist
I just tore down a 346 with an aftermarket top end........it just had one clip in it......
Deets066
Firewood hack
Mastermind
Work Saw Specialist
The top end went in the trash.........good used (ported) OEM jug, and new Meteor piston going back on.
Jon1212
Riff Raff Fart Knocker from other Forum's.
Father's Day gifts from my wife and kids.
The Homelite Bar and Chain Oil now resides on the window sill behind my bench.
Deets066
Firewood hack
I think all wrist pin clips should be like the 090 clips, those are so much easier to deal with
There was some thought behind that gift. Very nice Jon. This week I'm moving and I haven't touched a saw in weeks. It has taken me two full days to move my shop and I'm not done. I can't wait to get back into my saws.
Mastermind
Work Saw Specialist
Do I need a new address?
Jon1212
Riff Raff Fart Knocker from other Forum's.
Yes, ship all unclaimed 70-90cc saws to....
The Dirty Hippie
420 Glassbong Lane
Cacti Utah
Mastermind
Work Saw Specialist
I heard you were moving.......
Jon1212
Riff Raff Fart Knocker from other Forum's.
Mastermind
Work Saw Specialist
That will not work. This is a no hippie zone. Sorry
