Search results

Actually mine has started to do this also. I have a blazeking princess. Could the catalitic converter be going bad. Ive had mine for about seven years.

Just got my 511ax today for fathers day and both of the small grinding wheels were broken. Par for the course. Are the oregon wheels that come with them pretty cheap? I'm sure they will replace them..

Its 45 and raining in Montana probably snow in the mountains Gonna fire up the stove now.

keep your day jobs:biggrinbounce2:

Howdy, Just bought a pair of stihl pro mark chaps. It says to wash them before use. anyone know why? Thanks John

I realize I'm new here but here goes. I bought my MS361 with a 25 inch bar. I'm 6' 210 lbs. I cut my first couple of cords with the 25 inch bar seemed when carrying it around the bar end always went down like a magnet to the earth. When you sat it on the bench the front would go down to the...

Thanks Vince:blob5:

Bar mount sharpener What are the pros and cons about Granberg Bar-Mount Chain Saw Sharpener, Model# G-106B and the Stihl bar mount sharpener. Any one use these. How about the bench sharpener? Thanks John:monkey:

Im an amatuer and I bought the ms 361, I went up with my boss from work to get a small load or 2. I cut with my 361 and he didn't even get his little poulan out of the box except to cut the end off a couple for his truck. He couldn't mark out the eight footers with a pole and paint and haul as...

Thanks Fellas you guys are allright:clap:

I asked the same thing the other day. The responses I got can be found under my thread :blob3: MS 361 Parts

Hi Guys, I'd like to get to know my my new 361 parts better without taking it apart to see where everything is. From what I read here it leads me to believe its hard to get a hold of diagrams of parts , I believe I read only certified stihl dealers can get a service manual. I just would like to...

I've cut about 5 cords with my new ms361 and it really is impressive. I clean my saw after every session. I have been flipping the bar over every time. Is this good or bad? Thanks

electrobot, I just got a new Blazeking Princess last fall. It has a catylitic converter. Used half as much wood as I did before. The pine I burn is cut the year before so its dry. I cleaned my stainless steel chimney twice last year. Nothing really much in there , I do it for peace of mind...

Interesting comment by a member in the moisture post about his grandpa using salt when burning pine to cut down on cresote. Thats about all we have to burn her in Montana. Anyone else attest to this ? Does it help? Sounds interesting. I know I put softwater salt down the commode to help with...

Thanks guys, been cutting some subalpine fir in the mountains here in montana, pretty sappy, just wanted to be sure . Thanks again:blob3:

I have added a couple of pictures of the top of my chain. The brown spots, must be oil and sawdust. Should they be there or should they not? To much oil not enough? Thanks guys you are great:greenchainsaw:

thanks for the help. I did find the madsen site and it helped. I'll go by tomorrow and have them do it. Appreciate all your help, everyone.:chainsaw:

I have run a little over 10 tanks of gas thru my new 361. I believe I read on here I should take it back to the dealer to ck the setup. I called him and today and told him how much I had run it and when was a good time to bring it in for a check. He told me it wasn't necessary. I then told him I...

Well I would have to say my problems yesterday were operator error. I read the manual and made an adjustment to the idle per the book . Also didn't use full choke it started right up and never died once while I bucked up the cord of wood I got yesterday. Actually there is no comparison in...