What kind for lubrication should go in the gear case ? I found a reference that 0 .18 pint is its capacity, but I do not know what lubrication to use in the transmission.
Also, there is an hole in the housing at the rear of the saw ( see photo). The opening provides access to a threaded opening in the starter assembly cup. What is that design feature is for ? I wonder if I could be missing a part that goes there, or if this feature was created for use by someone repairing the starter assembly to get the fly wheel to spin. Any thoughts will be appreciated.
Also, there is an hole in the housing at the rear of the saw ( see photo). The opening provides access to a threaded opening in the starter assembly cup. What is that design feature is for ? I wonder if I could be missing a part that goes there, or if this feature was created for use by someone repairing the starter assembly to get the fly wheel to spin. Any thoughts will be appreciated.