Discussion in 'Chainsaw Stickies' started by jerrycmorrow, Jan 4, 2011.
runs good, lil stronger than friend's ts 400, so thought might be lil bigger.
Is a small diference at shee look like, but the engine is like oleomac 350 super. Thank you!
Thank you, i am from România. I will try to get more info..
Hi @Ciupav Gheorghe , did you see post #694 on the previous page? Only found an ipl and M.Acres site specs page.
Is anyone familiar with what parts on these saws interchange? Primarily the filter setups? I know there were two versions, im more interested in the early version where the filter screws to the base and then the filter cover screws to the filter. I am looking at finding a replacement and there seem to be plenty 254/264 covers out there but the model I need one for is the 284. All the components look the same, I just dont want to buy something and it doesnt cover the whole filter housing.
In case anyone is interested, this is on FB marketplace about an hour from me
Anyone know the ring dimensions for a 284?
I’d bet most any 52mm x 1.5 mm intended for a Stihl or Husqvarna would work.
Notch for horizontal locator pin is the normal.
Any ideas what models?
carl, my ipl says the bore is 47mm
I believe that would be for a 264...
Duh! I mistyped. Always meant 264. Thanks for catch
This my titan 70 oil pump, the saw was made in Italy ,didn't know if any other Italian makes are similar?
Separate names with a comma.