stihl460monster
ArboristSite Lurker
if your workin on a project saw throw up some pics and brag a little and share info if yall want!
Just have phone at the moment and dont think I can post pics.
Working on a MS880 Magnum, hopfuly finished in a couple of days. Very mild port job, expansion chamber finishing 2-3" behind rear handle. Cylinder sanded to give .018-.020" quench and outside painted black. Plastic cylinder cover replaced by custom steel cover which doubles as second mounting point for exhaust. Run either highest pump fuel or av gas.
Later possibly add reed valve and swap carb for 35mm Tillotson.
Work saw not race saw.
before(181)
durning
after(288)
Where do you get that filter and top for the 288?
from husky. part # 503-61-76-03
Enter your email address to join: