I find the 461 to run best with short blowdown and long intake.
This should be a good threadRemember boys when I get this one built and see gains or losses we have 1 more so number suggestions are more than welcome to compare the 2. I am basically trying to work up an really good work saw recipe for this saw. Hopefully this will benifit all.
What #s Brad?I find the 461 to run best with short blowdown and long intake.
Baby saw...I'd keep the exhaust down on the next one. Raising the exhaust doesn't always make more RPMs. Look at the 346. I find that they run best with the exhaust at 105°-107°.
If you took less out of the squish band, you could try one at 99 ex or so and go back if need be and correct.Remember boys when I get this one built and see gains or losses we have 1 more so number suggestions are more than welcome to compare the 2. I am basically trying to work up an really good work saw recipe for this saw. Hopefully this will benifit all.
Thats exactly where this one is headed. Lmao. But if above 102 kills them I won't explore that option. Thank you.
Derail away. This build thread will be slow as I don't have a lot of time in the evenings. The entertainment level must be kept up. Lol. I was just to anxious to see what u could do with one of these bad boys.I'm not sure that I could nail down any one thing that nets the biggest gain........
Let's see what the OP comes up with here........I've derailed enough. lol
View attachment 404434 And when I i saw come out from the base. I'm mean take the red lines straight into the bore.
NotI wouldn't touch it.
Not even case matching the base or just the sides?I wouldn't touch it.
If you're going after long bar torque leave it.Not
Not even case matching the base or just the sides?
Enter your email address to join: